Heating
A cold house in the middle of an Orem winter is not something to wait out. Whether the furnace will not start, the boiler has gone quiet, or a room that used to heat fine suddenly will not, we diagnose the actual cause and give you a straight answer before any work begins.
A furnace or boiler usually gives a specific symptom before it fails completely.
System will not run or produces no warm air
Blower runs but the air is not warm
No ignition, or it tries and gives up
Turns on and off in short bursts
Some rooms warm, others stay cold
Banging, screeching, or a burning odor
Hydronic system not circulating heat
System running longer for the same comfort
Most heating calls start with a furnace that will not do what it is supposed to: no heat, cold air from the vents, a unit that will not start, or one that cycles on and off too often. Furnace repair begins with reading those symptoms against the ignition sequence, flame sensing, airflow and control board rather than swapping parts and hoping. We carry the common failure parts on the truck, so most repairs finish the same visit once the cause is confirmed.
When a furnace is old enough, or damaged enough, that another repair does not make financial sense, furnace installation is the honest next conversation. That means correct sizing for your house, not just swapping in the same tonnage as before, plus a look at ductwork, venting and efficiency options so the new system actually performs better than the one it replaced.
A furnace that gets a fall check tends to avoid the worst winter breakdowns. Furnace maintenance covers the ignition system, flame sensor, blower, filter, safety switches and combustion readings, catching small wear before a cold snap turns it into a no-heat call. It is also the appointment where a technician will tell you honestly if a bigger repair is coming.
Homes with hydronic heat run on a different system entirely — a boiler, circulator pumps, zone valves and either radiators, baseboards or radiant floor loops instead of ductwork. Boiler service covers no-heat calls, poor circulation, zone valve failures and the periodic maintenance these systems need to keep running efficiently for decades.
Some homes heat and cool with a heat pump instead of, or alongside, a furnace. It is a legitimate option worth comparing against a conventional gas furnace, particularly for homeowners weighing efficiency and electrification. We service both and can walk through which setup fits your house and your utility situation.
A furnace or boiler can only respond to what it is told, and an inaccurate or failing thermostat causes real comfort complaints that have nothing wrong with the heating equipment itself. Miswired, misplaced or worn-out thermostats show up as short cycling, rooms that never reach set temperature, or a system that seems to run at the wrong times.
Combustion heating equipment produces carbon monoxide when it runs, and a cracked heat exchanger, blocked flue or venting problem can let that gas into the house instead of outside. Every furnace and boiler visit includes a check of venting, flue connections and combustion readings. A working carbon monoxide detector near sleeping areas is a basic safety step every home with gas heat should have.
The decision usually comes down to age, repair cost and how the system has behaved. A furnace or boiler under ten years old with a single failed part is almost always worth repairing. One in its late teens or twenties, especially with a costly repair like a cracked heat exchanger or failed control board, is often better replaced. We lay out both numbers so you can decide, rather than defaulting to whichever is more profitable for us.
Utah County winters put real demand on a heating system, and the housing stock here spans everything from older homes with original ductwork and aging boilers to new builds with modern high-efficiency furnaces. That range is why our trucks carry parts for both eras. Serving Orem and the surrounding Utah County communities every day means we see the same equipment and the same winter failures on repeat.
Heating repair and replacement costs vary based on a handful of factors we walk through before quoting.
We always diagnose first and quote a flat price before any work begins.
If your furnace or boiler stops heating, try the thermostat and breaker first, then call before the house gets uncomfortably cold. A same-day diagnosis is almost always cheaper than an emergency call at midnight.
Typical calls our technicians run from the Orem shop.
Orem
A common call involves a furnace that clicks but never lights, traced to a failed igniter and a dirty flame sensor, both replaced the same visit.
Utah County
A common job is a single cold bedroom caused by a closed or disconnected duct damper rather than a furnace problem at all.
Orem
A common call is a hydronic system heating unevenly because a circulator pump was failing, fixed with a pump replacement and a system bleed.
864 N 1430 W in Orem — the same shop for every job we run in Utah County.
Water, heat and air under one roof, which matters when a problem crosses lines.
We find the cause before recommending work, so you are not paying for guesses.
When a repair still makes sense we say so, and when it does not we explain why.
We work from Orem outward, which keeps drive times short across the north end of Utah County and reasonable everywhere else we serve.
Call (801) 226-3033 to schedule furnace or boiler service, or request an appointment online. We diagnose first and quote a flat price before any work starts.
